Status
The status subcommand reports the status of the UQ runs.
To run the command:
duqtools status
Check out the command-line interface for more info on how to use this command.
The status
config
The options of the status
subcommand are stored under the status
key
in the config.
These only need to be changed if the modeling software changes.
status_file
- Name of the status file.
in_file
- Name of the modelling input file, will be used to check if the subprocess has started.
out_file
- Name of the modelling output file, will be used to check if the software is running.
msg_completed
- Parse
status_file
for this message to check for completion. msg_failed
- Parse
status_file
for this message to check for failures. msg_running
- Parse
status_file
for this message to check for running status.
Note
Both out_file
and in_file
may be parsed to track the progress of the individual runs.
Example
duqtools.yaml
status:
in_file: jetto.in
msg_completed: 'Status : Completed successfully'
msg_failed: 'Status : Failed'
msg_running: 'Status : Running'
out_file: jetto.out
status_file: jetto.status